Specifications

105
Audio Support with Optional VoIP Intercom
Figure 37: VoIP Gateway Maintenance Utility at Start-up
Figure 38: VoIP Maintenance Utility with a Single Card Selected
♦ Resetting the VoIP intercom board to defaults:
1. Remove power from the Station Transponder unit in question.
2. Locate the two volume control buttons on the VoIP intercom board (these will be
the two blue buttons). Press and hold both buttons.
3. While continuing to press both buttons, power-up the station transponder unit.
4. Wait for 8 seconds after powering up the unit and then release the buttons.
5. The VoIP intercom board is now reset to defaults. When you try the procedure for
configuring the board again, the VoIP intercom board should show up on the list of
units detected.