Product manual

Installation
46 025-9158L
Figure 16: PA Configuration Menu
Wait for Dispatcher Timeout
This parameter is found in the PA Configuration Menu. It holds the maximum period of
time, in seconds, that the Model 26 will wait for the dispatcher to keyup after all the
Model 6 PAs are ready. If this parameter times-out before the dispatcher’s microphone is
keyed, the Model 26 will send a PA OFF command to all Model 6s. This parameter
accepts a value between 0 and 99 seconds. A typical time-out value would be 10 to 15
seconds.
Hold After Dispatch Timeout
This parameter is found in the PA Configuration Menu. It is the maximum period of time,
in seconds, that the Model 26 will wait after the channel has been unkeyed before it sends
a PA OFF command to all Model 6s. This parameter accepts a value between 0 and 99
seconds. A typical time-out value would be 3 to 7 seconds.
Port Configuration Menu
This menu selection is found in the Main Menu. It configures the mode of operation and
sets the baud rate for the CAD/PRINTER port located on the rear panel of the Model 26.
The CAD/PRINTER port supports three different functions. This menu selects between
two of these functions, CAD and Data Logging. The third function, Software
Configuration Program, is enabled or disabled directly by switch 7 on the OPTION
SWITCH DIP, (located on the rear panel of the Model 26).