Product manual

Switches
15
Configuration
Switches
The overall behavior of the jackbox is configured with the 10 DIP switches located in the
center of the rear panel. The following table lists the functions of the various switches
and indicates the default settings configured at the factory.
Table 4: Dual-knob/Single-knob Headset Jackbox Switches
Switch Function Down Up
1
Jack sense Jack sense enabled *
(Headset presence detected
by headset jack connected.)
Jack sense disabled
(For compatibility with
legacy Zetron equipment.)
2
6-wire PTT – 6-wire headset 4-wire headset (no PTT) *
3
6-wire PTT + 6-wire headset 4-wire headset (no PTT) *
4
Pot 1 ch1 only
5
Pot 2 sum
6
Pot 1 ch2 sum
7
Single pot
Switches 4 through 7 should be set in certain patterns based
on the desired audio input and knob behavior. See Table 5.
8
Mouth bypass
1
Parallel microphones * Primary mic only
9
PTT – to Ear – PTT share ground with Ear Separate ground PTT – *
10
Mouth – to Ear – Mouth share ground with Ear Separate ground MIC – *
* Factory default setting.
1
This switch determines the microphone behavior when more than one headset jackbox is used.
Parallel microphones (switch down) attempts to use both microphones, but this can cause
problems or not work with certain types and combinations of microphones. Primary mic only
(switch up) mutes the extended headset’s microphone if the primary headset is plugged in.