Instruction manual

Installation
025-9416 83
Notes on Figure 48:
1. The cross-wiring between the two punchdown blocks is not as straight-forward as Figure 48 may suggest. Wiring
is dependent on the telco line types and the system application.
2. In the Transmitter Key Type database set:
M68 = “On”
3. In the Transmitter Key Up Control database set:
RqstSgnlPlrty = “high”
Be sure to consult Table 12 before making a cable or cross-wiring the punchdown blocks. Also
refer to the Model 68 Transmitter System Controller Operating and Installation Manual (Part
No. 025-9089) for details on connecting the unit to other radio station equipment.
Table 12. Model 640 to Model 68 Interface Wiring Configuration
MODEL 640 MODEL 68
Signal Name 50-pin RJ21
Output (J1)
Terminal Block
Output
50-pin RJ21
Input (J1)
REC AUDIO HI 13 P1-12 1
DIG MODE 14 P2-10 2
XMIT AUDIO LO 15 P1-2 3
COR / CAS 16 P1-4 4
GROUND (signal) 17 P1-1 5
ANA PTT COM 18 P1-6 6
ANA PTT NC 19 P1-7 7
DIG PTT COM 20 P2-8 8
ZONE ADR 8 21 P2-6 9
ZONE ADR 2 22 P2-4 10
AUX PTT NO 23 P1-8 11
AUX PTT COM 24 P1-9 12
REC AUDIO LO 38 P1-11 26
XMIT REQUEST 39 P2-11 27
XMIT AUDIO LO 40 P1-2 28
BUSY 41 P2-2 29
DIG DATA 42 P2-12 30
ANA PTT NO 43 P1-5 31
DIG PTT NC 44 P2-9 32
DIG PTT NO 45 P2-7 33
ZONE ADR 4 46 P2-5 34
ZONE ADR 1 47 P2-3 35
AUX PTT NC 48 P1-10 36
GROUND (chassis) 49, 50 P2-1 37