Instruction manual

Communications Setup
38 025-9416
CAUTION
Do not attempt to run MCU from MS Windows. The computer will not be able to link
properly to the paging terminal and a system crash may result.
q
1. Boot up the office computer in MS DOS.
q
2. Change to the MCU installation directory (default \MCU), by typing:
CD MCU
q
3. Run MCU, by typing:
MCU
q
4. From the MCU main menu, select Edit, Locations. The Locations Index window
appears.
q
5. Press <F9> to start a new record. The Comm Window shown in Figure 14 appears.
Figure 14. MCU Comm Window
q
6. Enter an appropriate name for the Paging Terminal Site. The name is a text string, up
to 8 characters in length.
q
7. If the ZLINK connection is made by a remotely located PC modem, enter the
complete Phone Number to dial for site connection. Use the following special
characters as needed (refer to modem manual for supported commands):
, = insert a pause in the dialing sequence
P = use pulse dialing
Example: For DID lines that require (4-digit) overdial of the subscriber PhoneNumber,