Instruction manual

Communications Setup
025-9416 33
q
1. Start up the office computer. From the Windows Desktop, switch to the DOS
command-line prompt.
q
2. Insert the MCU installation diskette into the appropriate floppy drive. (Drive A: in
the following examples.)
q
3. Switch to drive A: (if the blinking DOS prompt is not already “A:\>”), by typing:
A:
q
4. At the DOS “A:” prompt, type:
INSTALL <Enter>
The installation program presents the screen shown in Figure 9.
q
5. Enter “y” if the default installation directory is acceptable.
Enter “n” to choose a different installation directory. The instructions shown below
appear. Restart the installation at the DOS prompt using a command that specifies the
desired installation directory as described in the help screen.
--------------------------------------------------------------------------
This installs MCU, the Zetron 640 Series Office
Computer Software, onto a HARD DISK IBM PC or clone.
_
This will install from the floppy disk in drive: A:
This will install to the drive and directory: C:\MCU
_
(if you get a DOS error next, choose Fail)
_
Are the above drive letters and path OK? (y/n)
Figure 9. MCU Installation Screen
q
6. Enter “y” at the “Do you wish to do the installation (y/n)?” prompt to begin
transferring the files to the office computer.
The installation process is done automatically and the DOS prompt returns.