Instruction manual
Optional Equipment Installation
025-9416 105
16 8 c:\zdir\newfilename.img
where newfilename.img is the name of your new image file.
f. Save the file by pressing Alt+F, then S.
g. Exit the file by pressing Alt+F, then X.
h. At the + prompt enter:
put config.cds
6. Modify configuration file Network.cus.
a. At the + prompt enter:
ls network.cus
If the file is not found, enter:
get network.cus
b. At the + prompt enter:
dos edit network.cus
c. Add a line of the following form for each internal destination entry in Table 1. Place
doublequotes around the 8-character name.
outbound "8-char name from Table 1" 3 TAP00D x|yS
Include the x|yS part only if also sending pages to the local RF paging transmitter. For
x put the RF Channel (for example, 1). For y put the RF Zone (for example, 0).
d. Save the file by pressing Alt+F, then S.
e. Exit the file by pressing Alt+F, then X.
f. At the + prompt enter:
put network.cus
M640 Subscriber Database Programming
This section defines how the actual ID# on your system will be routed externally to an ID# on
the remote paging provider’s system.
Note: You can enter ? at any prompt for a list of options and/or descriptions of the parameter.
1. Set up the Class of Delivery Service database.
a. From the Model 640 Databases menu select 1 - Subscriber Phone Numbers.
b. From the Subscriber Phone Numbers menu select 4 - Class of Delivery Service
Database.
c. At the Entry prompt enter N (for New).
d. Enter the following information.
Delivery:
8-character name from Table 1
Firstzone:
(none — just press spacebar)
FirstRepeat: 0
FirstDelay: 0