User manual

ManualsBrandsZeta Alarm Systems ManualsHome building and DecorInfinite 8

INFINITY 8 USER MANUAL, MAINTENANCE GUIDE & LOG BOOK

Approved Document No: GLT-201-7-2 PAGE 7

Issue: 1.2 Authorised: Date: 27/3/2012

(e.g. cooking smoke), the smoke will have to be cleared from the room before the panel can be reset. Reset

the panel by pressing the after the sounders and panel buzzer have been silenced.

 If the call point is still active, or the detector is still smoky, this will cause another alarm straight after the

panel is reset, so will set off alarm bells again.

6. THE FAULT CONDITION

6.1 DIFFERENT TYPES OF FAULT

The fire alarm monitors itself, and any equipment connected to it, for any faults that can occur. If a fault occurs, the Panel

responds by activating its Internal buzzer and lighting the General Fault light and any other Fault light(s) relevant to the

particular fault. The Panel’s Fault relay will also activate. Typical faults are described below: -

General Fault

The General Fault LED is a common indicator that flashes

when there is a Fault on any part of the Fire Alarm Systems.

It is usually lit in tandem with at least one other fault light

which conveys more precise information on the type of

Fault detected.

Zone Fault

The relevant Zone Fault light flashes when there is a

wiring problem on a Zone or detector has been removed from

its base. It should be noted that any alarms raised on the

fault zone(s) may not be recognised by the Fire Alarm Panel

until the Fault Conditions have been cleared. It can take up to

60 seconds from repairing a fault for the display to clear.

Short Circuit Fault

If the Fault is a short circuit fault, then the S/C LED will be flashing.

This S/C LED will be flashing for S/C faults on the zone

and sounder circuits. It can take up to 60 seconds from repairing

a fault for the display to clear.

Power Supply Fault

The Power supply Fault light flashes when the Mains supply

has failed or the standby batteries or its charger is faulty. If

the mains supply fails, the panel will only operate for the

standby period dictated by the size of the batteries fitted. If

the batteries or charger fails at the same time as the Mains,

the Panel will be inoperative.

POWER

GEN-FIRE

GEN-FAULT

SUPPLY FLT

SYSTEM FLT

GEN-S/C

DEL

GEN-ZONE TEST

GEN-DISABLEMENT

765432

1 8765432

FIRE / ZONES

ZONAL FAULT / DISABLEMENT / TEST

1 2

ENGINEER

STOP-START SILENCE RESET SCROLL /

/ LED TEST

FLT TONE

DELAY

OVERRIDE

FLT