User's Manual

Charge the Palm Pilot
Press and hold the power button for 2
seconds to turn on the Palm Pilot. Then, select
and connect to the Hover 2 hotspot with the
Direction Control Stick (press down to select).
*
If the Hover 2 hotspot is not found, press and hold the Wi-Fi /
RC toggle button on the drone for 4s, and try to connect
again after hearing the beep.
Connect Hover 2
Takeoff Hover 2
Push the Altitude Control
Wheel up for 2 seconds to
takeoff.
Push the Altitude Control
Wheel down until Hover 2
lands on the ground, hold
for 2 seconds to stop the
propellers.
Controlling Hover 2
Landing Hover 2
Right
Up
Down
Gimbal Up
Gimbal Down
给掌上 RC 充电
连接 Hover 2
长按电源键 2 秒开机，使用水平方向控制摇杆
选择并按下摇杆连接 Hover 2 热点。
*
若未找到 Hover 2 热点，请长按机身上的 Wi-Fi / RC 控制模式切换
按键 4 秒，听到嘀嘀声后再次尝试连接。
放飞 Hover 2
向上推上下方向滚轮 2 秒，
Hover 2 将自动起飞。
向下推上下方向滚轮至 Hover 2
落地，落地后继续推 2 秒，螺旋
桨将停止旋转。
收回 Hover 2
Plug the charging cable into
the USB-C Port.
It takes about 2.5 hours to
fully charge.
100%
接入 USB-C 充电线 完全充满大约需要 2.5 小时
使用掌上 RC 控制飞行
Left
Forward
Backward
Turn LeftTurn Right
Hover_2-XXXXXX
Hover_2-XXXXXX
Hover_2-XXXXXX
Searching Results…
100%
100%
上升
下降
云台向上
云台向下
前
后
右
左转
右转
Hover_2-XXXXXX
Hover_2-XXXXXX
Hover_2-XXXXXX
100%
左