User Manual

ZEROTECH (Beijing) Intelligence Technology Co., Ltd. 33
as using the “Shutter” button.
 The default mode is set to single shot. You can tap the “Camera Settings” button
to switch between the single shot mode and the burst shot mode, and select how many
photos to take (3 photos by default) in the “Modes” menu. Please refer to “Camera
Settings” on page 17.
 The photo timer is closed by default. You can tap the “Photo Timer” button to
activate the photo timer and select the countdown. Please refer to “Photo Timer” on
page 17.
EIS
EIS (Electronic Image Stabilization) can deblur the images of a video, eliminating jitter, jelly, etc. It applies
to both the conventional video recording and the 10s auto-track short video recording. We suggest you
enable it.
How to enable EIS: Tap the “Camera Settings” button, and select any of the lens angles in
“Settings” - “EIS”. Please refer to “Camera Settings” on page 17. EIS needs to be enabled once again
each time you open the app.
How to disable EIS: When the temperature of the aircraft reaches 70°C or you quit the app, EIS will
automatically be disabled. Also, you can close EIS in “Camera Settings” - “Settings” - “EIS”.
Conventional Video Recording
1. Tap the “Photo/Video Switch” to go to the conventional video recording interface.
2. The conventional video recording interface is as follows. Tap the “Record” button to start
recording. Tap the “Stop Recording” button on the right hand side of the interface to end your
recording. Conventional video recording can last as long as you want. The duration will be displayed
at the bottom of the interface.