Instruction manual

Setup
Page 70 Solution & Solution XL Operating Manual – Issue 1.0
this stage, you should see the Zero 88 network listed. Select it and choose
connect (if you added security, you'll need to enter these details here).
Once the smartphone is connected and the desk is connected, on the desk go
to Setup / Network / Remote. Choose Enabled Remote - Yes, and Use DHCP
Address - Yes. Again, enable security if you like (this security is simply a
password the remote will prompt you for before connecting)
At the bottom of the remote setup screen, a message should appear -
"Remote Active". If "Remote Not Active - No DHCP Address" is displayed,
ensure that DHCP is enabled on the router and reboot the desk.
Assuming "Remote Active" is displayed and the smartphone connected to the
wireless network, you should be able to start the ZerOS Remote program on
the device and the desk should be detected. Press on the Desk name and
click the connect button.
For full information on the Remote, see the Remote chapter in this manual
(Page 143).