Instruction manual

Outputs Screen
The Outputs screen on the monitor
shows either the desk channel outputs
(generic and fixture channels), or the
DMX outputs depending on the current
option shown on the main LCD.
DMX Outputs
This screen shows the current output
levels for DMX channels 1 - 512.
Frog - The DMX output levels for
universe A.
Fat Frog - The DMX output levels for
universe A.
Leap Frog - The DMX output levels for
universe A.
Bull Frog - The DMX output levels for
either universe A or universe B.
The DMX output levels are colour
coded as follows:
Level rising Green background
Level falling Red background
Level static Grey text.
Desk Channel Outputs
The Desk Channel Outputs screen is
divided into three main sections as
described below:
Generic Channels - This section
shows the current output levels of each
of the generic channels, displayed as a
percentage. The output levels are
colour coded as follows:
Level rising Green background
Level falling Red background
Level static Grey text
Fixture Brightness Channels - This
section shows the current output levels
of the fixture brightness channels,
displayed as a percentage. The output
levels are colour coded as follows:
Level rising Green background
Level falling Red background
Level static Grey text
Primary Selected Fixture - This
section shows the current output levels
for all the parameters of the “Primary”
selected fixture. If no fixtures are
currently selected, this section is blank.
The Brightness parameter is shown as
a percentage; all other parameters are
shown as DMX values (0-255).
If a fixture parameter is 16 bit, it is
shown on the monitor screen as
coarse and fine values (eg 123-100).
The fixture parameters currently
assigned to the control wheels are
highlighted on the monitor screen.
Fixture Outputs Screen
Fat Frog - This screen shows all the
fixture parameter output values for
fixtures 1-12.
Leap Frog and Bull Frog - This
screen shows all the fixture parameter
output values for 12 consecutive
fixtures starting at the fixture specified
by the user.
For example, press and hold F1 then
press FIXTURE SELECTION button 7.
The Fixture Outputs Screen will show
the parameter output values for fixtures
7-18 inclusive.
The output values of Brightness
parameters are displayed as a
percentage. All brightness parameters
are displayed as “Dimmer” regardless
of their actual name in the fixture data.
The output values of Colour,
Beamshape and Position parameters
are displayed as DMX values (0-255).
Any 16-bit parameters are split over
two lines, the first line showing the
Coarse (or MSB) value, the second
line showing the Fine (or LSB) value.
The fixture parameters are grouped
into their respective attributes and
displayed in the following order:
Brightness (dimmer), Position, Colour,
Beamshape.
Each attribute has a different
background colour on the monitor
screen.
Frog Series 73-750-00 Issue 6 7 - 11
Other Features
Figure 7 - 6: Desk Channel Outputs Screen (Monitor)