Instruction manual
Set Lock Code
This function allows the user to set the
lock code for the desk. See page 7-3
for details on the lock function.
Setting the Lock Code
1. Select the Set Lock Code option
from the Super User screen and
press the ENTER key. The
following is displayed on the LCD:
Enter current lock
code using submaster
flash buttons:
[OK] {Cancel}
2. Enter the current 4 digit lock code
using SUBMASTER FLASH
buttons 1 - 10.
As each digit is entered, it
appears on line 3 of the LCD. For
example, if the code was 1234:
Enter current lock
code using submaster
flash buttons: 1234
[OK] {Cancel}
3. Press the ENTER key. If the
correct code is entered, the
following is displayed on the LCD:
Enter new lock
code using submaster
flash buttons:
[OK] {Cancel}
If an incorrect code is entered,
an error message is displayed on
the LCD.
4. Enter a new 4 digit lock code
using the SUBMASTER FLASH
buttons. As each digit is entered,
it appears on line 3 of the LCD.
5. Press the ENTER key. A
confirmation message is
displayed on the LCD:
New Lock Code Set
[OK]
6. Press the ENTER key to clear the
message and return to the Desk
Setup screen.
Desk Information
This Super User function provides the
following desk information on the main
LCD screen:
• SERIAL NUMBER
The full serial number of the desk.
•
SOFTWARE VERSION
The version of the operating system
software installed in the desk.
•
BIOS VERSION
The version number of the BIOS in the
desk.
•
BATTERY STATUS
The status of the internal battery. This
normally shows “OK”. If it says “FAIL”
contact your dealer or Zero 88.
•
CURRENT SHOW
The show number and date if the show
on the desk was originally loaded from
floppy disk.
Reading the Desk Information
1. Select the Desk Information
option from the Super User
screen and press the ENTER key.
The LCD shows the following:
* DESK INFORMATION *
Serial Number ^
xxxxxxx xxxxxxxx v
[EXIT]
2. Use the up or down arrow keys to
cycle through the various desk
information described above.
3. Press the ENTER key to exit the
Desk Information screen and
return to the Super User screen.
Reset DMX
This function resets the DMX outputs
for a few seconds, then returns them to
their previous output values.
Resetting the DMX
1. Select the Reset DMX option from
the Super User screen and press
the ENTER key. The LCD shows
the following:
***** RESET DMX ****
Do you wish to
reset the DMX?
{OK} {Cancel}
2. Press the ENTER key to reset the
DMX, or select the Cancel button
and press ENTER to cancel. The
LCD returns to the Super User
screen.
Exiting Super User
Select the Exit Super User option from
the Super User screen, as shown
below:
**** SUPER USER ****
{Illumination} ^
{Set Date & Time}
{Exit Super User}
Press the ENTER key. The LCD
returns to the Memories screen.
Frog Series 73-750-00 Issue 6 6 - 15
Super User