Instruction manual

Copying Memories
The COPY button is used to copy a
complete memory from one location to
another.
The function performed (Copy To or
Copy From) is dependent on the status
of the selected memory as described in
the sections below.
If there is not sufficient memory to
perform the copy function a warning
message is displayed on the LCD.
Copying to a Memory
1. Select an unprogrammed
memory.
2. Press the COPY button on the
front panel. The LCD display
changes to the following:
Copy Memory
From: <1>
To: <n*>
[OK] {Cancel}
3. Use the + and - keys to select a
source memory to copy from.
Unprogrammed memory numbers
will be skipped over.
4. Press the ENTER button to
confirm the copy operation. The
source memory is copied into
destination memory, and the LCD
returns to the Memories screen.
Copying from a Memory
1. Select a programmed memory.
2. Press the COPY button on the
front panel. The LCD display
changes to the following:
Copy Memory
From: <1>
To: <n*>
[OK] {Cancel}
3. Use the + and - keys to select the
destination memory to copy to.
Unprogrammed memories will be
indicated with a ‘*’.
4. Press the ENTER button to
confirm the copy operation.
If the destination memory is
unprogrammed, the source
memory will be copied into the
destination memory, and the LCD
returns to the Memories screen.
5. If the destination memory is
programmed, a warning message
is displayed on the LCD:
***** WARNING ******
Memory is programmed
Overwrite memory ?
[YES] {NO}
Press the ENTER button to select
the YES option and overwrite the
memory.
Frog Series 73-750-00 Issue 6 4 - 13
Memories
Figure 4 - 2: Memory Controls