Instruction manual

Jumps in the Memory Stack
The Jump function provides the facility
to jump to a specified memory when
the current memory is complete.
The Jump data is displayed on the
Memories screen on both the main
LCD and monitor (if fitted).
Programming a Jump
1. Select the memory which is the
start point of the jump.
2. Use the up or down arrow keys to
select the Jump field.
3. Use the + or - keys to select the
memory number to jump to.
Editing a Jump
1. Select the memory which is the
start point of the jump.
2. Use the up or down arrow keys to
select the Jump field.
3. Use the + or - keys to select a
different memory number.
Deleting a Jump
1. Select the memory which is the
start point of the jump.
2. Use the up or down arrow keys to
select the Jump field.
3. Use the + or - keys to set the
Jump field to None.
Inserting Memories
The desk provides the facility to insert
up to a maximum of nine point
memories between two whole number
memories (eg memories 3.1, 3.2 … 3.9
between memories 3 and 4).
Memories are inserted one at a time,
and can only be inserted after the
currently selected memory.
Inserting a Memory
1. Select a memory on the
Memories screen.
2. Press the INSERT button on the
front panel.
The Insert Memory screen is
displayed on the LCD. The default
number is the next highest insert
memory number:
*** Insert Memory **
Number : < 1.1>
[OK] {CANCEL}
3. Use the + and - keys to select a
different insert number, if
required.
4. Press the ENTER button. The
LCD returns to the Memories
screen, showing the new
unprogrammed insert memory:
Current: 2 s
Next: < 1.1 *>
Fade Up: <00:03.0>
Fade Down:<00:03.0>v
5. The new insert memory can then
be programmed as normal.
6. To insert another memory, for
example between 1.1 and 2,
select memory 1.1 and press the
INSERT button. Repeat the
above procedure.
NOTES
Jumps in the Memory Stack
Jumps can be used to repeat a section of the
memory stack, or to miss out a section of the
memory stack, as required.
It is not possible to jump from Memory Zero.
Inserting Memories
Memories cannot be inserted between a
whole number memory and its first insert
(eg 1 and 1.1), between two consecutive
insert memories (eg 1.1 and 1.2), or between
the last insert memory and the next whole
number memory (eg 1.9 and 2).
An error message is displayed on the LCD if
any of the above are attempted.
When using the + or - keys to select the
Next memory on the Memories screen, only
programmed insert memories are shown.
4 - 12 Frog Series 73-750-00 Issue 6
Memories