Instruction manual

Manual & Timed Crossfades
Crossfading between the scene set up
on the PRESETS and the stored scene
is achieved by moving the A MASTER
and B MASTER faders in tandem.
If the CROSSFADE control is set to
Manual, the crossfade time is
determined by the speed at which the
A MASTER and B MASTER faders are
moved. The operator has direct control
over the speed of the crossfade.
If the CROSSFADE control is not set to
manual, the crossfade time will be the
time indicated on the CROSSFADE
dial (1 second to 5 minutes).
Flashing Channels
When a channel is flashed, its level is
raised to that of the GRAND MASTER.
All other channels remain at their
current levels.
1. Set the flash function to Flash
using the FLASH FUNCTION
button.
2. Use the SHIFT button to select
the required channels.
3. Press and hold an individual
CHANNEL FLASH button. The
corresponding channel is added
to the scene at the level set on
the GRAND MASTER.
4. Release the CHANNEL FLASH
button. The channel returns to its
previous level.
Soloing Channels
When a channel is soloed, its level is
raised to that of the GRAND MASTER.
All other generic channels and fixture
brightness channels (if applicable) are
reduced to zero.
1. Set the flash function to Solo
using the FLASH FUNCTION
button.
2. Use the SHIFT button to select
the required channels.
3. Press and hold an individual
CHANNEL FLASH button. The
corresponding channel is raised
to the level set on the GRAND
MASTER.
4. Release the CHANNEL FLASH
button. The channels return to
their previous levels.
Frog Series 73-750-00 Issue 6 3 - 5
Preset Operation
Figure 3 - 5 : Preset Controls