Instruction manual

Wide Operation
When operating in Wide the user is
able to crossfade between, or combine
two full width scenes.
A scene is set up using the PRESET A
and the PRESET B faders . The scene
is then stored in memory by pressing
the PRESET CONTROL button.
A second scene can then be set up on
the PRESET faders. The A MASTER
and B MASTER faders can then be
used to crossfade between the two
scenes.
The PRESET CONTROL button is
used to control which master has
control of the PRESET faders and the
stored scene. The accompanying red
lights indicate the current state.
The CROSSFADE control is used to
adjust the crossfade time between the
two scenes. The GRAND MASTER
fader is used to control the final output
levels from the desk.
Setting up for Wide Operation
Press the WIDE button to select Wide
operation (if not already selected).
On first selecting Wide or re-entering
Wide operation, the PRESET faders
are assigned to the A MASTER, and
the stored scene assigned to the B
MASTER. The temporarily stored
scene will be cleared.
Storing and Cross Fading
Scenes in Wide
1. Set the A MASTER and GRAND
MASTER faders to full, and the
B MASTER to zero. Set the
CROSSFADE control to Manual.
2. Check that the lights next to the
PRESET CONTROL button
indicate A FADERS, B STORED.
3. Set up a scene using the
PRESET A and PRESET B
faders. This scene will be output.
4. To store the scene press the
PRESET CONTROL button. The
output levels are temporarily
stored and the red lights next to
the PRESET CONTROL button
change to show B FADERS, A
STORED. The A MASTER is now
assigned to the stored scene and
the B MASTER assigned to the
PRESET faders (the outputs
remain the same).
5. Set up the next scene using the
PRESET A and PRESET B faders
(The outputs are not affected
since the B MASTER is currently
at zero).
6. To crossfade between the stored
scene and the scene on the
PRESET faders, simultaneously
move the A MASTER to zero and
the B MASTER to full. A dipless
crossfade will occur with the
stored scene fading out and the
scene set on the PRESET faders
fading in.
7. If the PRESET CONTROL button
is pressed again, the output levels
are saved into the temporary
store (overwriting the previous
values) and the red lights next to
the PRESET CONTROL button
change to show A FADERS, B
STORED. The B MASTER is now
assigned to the stored scene and
the A MASTER assigned to the
PRESET faders, so the outputs
remain the same.
8. The operations described in steps
3-7 can then be repeated as
required to effectively produce a
two preset desk controlling all the
generic channels.
3 - 4 Frog Series 73-750-00 Issue 6
Preset Operation
Figure 3 - 4: Preset Controls