Instruction manual

Soft Buttons
Soft buttons are indicated on the LCD
using square brackets ([…]) and curly
brackets ({…}).
Where a display contains more than
one soft button (eg OK and CANCEL),
the default button is indicated by
square brackets. A selected button is
highlighted (ie flashing).
The up and down arrow keys are used
to select the required soft button.
The selected soft button on the LCD is
actioned by pressing the ENTER
button on the front panel.
Example - a warning message with two
soft buttons (Yes and No):
***** WARNING ******
Memory is programmed
Overwrite memory ?
[YES] {NO}
The YES button is the default button
and also the currently selected button.
Pressing the ENTER key on the front
panel will activate the YES button.
***** WARNING ******
Memory is programmed
Overwrite memory ?
[YES] {NO}
In the above display, the NO button is
selected. Pressing the ENTER key will
activate the NO button.
Long Lists
On several of the LCD screens, there
are more editable options and/or soft
buttons than will fit on the four lines of
the LCD display.
In these situations, up and down arrow
characters are displayed on the right
hand side of the LCD screen to show
there are further options available.
The up and down arrow characters are
shown as ‘^’ and ‘v’ respectively in this
manual.
When the up and down arrow keys are
used to scroll up and down the list of
options and buttons, the screen title
remains displayed on line 1 of the LCD
and Lines 2 – 4 on the LCD will change
accordingly.
For example - The LCD screen below
contains a title, six editable options and
an Exit button.
*** SCREEN TITLE ***
Option 1: <100%>
Option 2: <100%>
Option 3: <100%> v
The ‘v’ indicates that there are one or
more options below Option 3.
Pressing the down arrow key 3 times
will select Option 4 and the LCD will
show the following:
*** SCREEN TITLE ***
Option 2: <100%> ^
Option 3: <100%>
Option 4: <100%> v
The ‘^’ indicates that there is one or
more options above Option 2. The ‘v’
indicates that there are one or more
options below Option 4.
Pressing the down arrow key 3 times
will select the Exit button and the LCD
will show the following:
*** SCREEN TITLE ***
Option 5: <100%> ^
Option 6: <100%>
[Exit]
The ‘^’ indicates that there is one or
more options above Option 5. The Exit
button is the last option in the list.
Frog Series 73-750-00 Issue 6 1 - 9
Introduction
Figure 1 - 8: Memory Controls