Instruction manual

Setup
Frog 2 Operating Manual – Issue 4.3 Page 67
Loading Shows
To load a show, connect the storage media to the USB port on the desk (any port).
If you’re using an external floppy drive, remember to insert the floppy disk into the drive.
Press the [Files] key on the touch screen.
Press the [Load Show] key on the touch screen. The Load Show Window is displayed on
the touch screen:
Select the storage device by pressing on the [Source Device] toggle box. This will cycle
through all the available devices, so select the one you require.
Select the required show from the list of available shows displayed.
Select the [Load Complete Show] box and toggle it until it displays the option you require.
The Frog 2 allows you to load just the Setup, the Setup and Palettes, or the Complete
show.
Press the [OK] button to load the show.
Note – Loading Shows
Loading a show file will clear any existing show data from the desk so ensure that you
have backed up your previous show before you load another one onto the desk.