Instruction manual

Setup
Page 54 Frog 2 Operating Manual – Issue 4.3
Changing Fixture Type
This patch function allows you to swap one fixture type for another.
Individual fixtures or groups of fixtures may be changed in a single operation.
The desk attempts to clone the programmed data for the swapped fixture(s) in memories,
submasters and palettes as far as possible.
Parameters in the new fixture type that were not present in the original fixture type are left
unprogrammed.
Select the fixture(s) to be changed. Go to the [Type] column in the window:
Select the [Change] button for the required fixture or the [Change] button in the ALL row to
change the type of all the selected fixtures.
Select the Manufacturer, Fixture Type and Mode (if applicable) using the MFKs or via the
popup window on the monitor and confirm the change type operation.