Instruction manual

Setup
Frog 2 Operating Manual – Issue 4.3 Page 49
Aligning Fixtures
The Frog 2 desk is capable of making adjustments to your fixtures to take into account
their rigging position.
Inverting Pan and Tilt
It is possible to invert Pan and Tilt independently for each fixture. This can be particularly
useful if you’ve rigged Front of House fixtures the opposite way around to those onstage,
for example:
Use the arrow keys to move the cursor to the Invert P or Invert T column of the required
fixture and then press the SET key. Use the left and right arrow keys to toggle between the
values Yes and No. Select the required value and then press the ENTER key
Now any adjustments you make to the parameter you changed will be inverted in the DMX
outputs, making all your fixtures move in the same direction relative to the wheels.
Swapping Pan and Tilt
If a fixture is rigged on its side, you may also wish to Swap the Pan and Tilt parameters. In
this function, any values defined for Pan will be output on the Tilt channel(s), and any
values defined for Tilt will be output on the Pan channel(s).
Use the arrow keys to move the cursor to the P/T Swap column of the required fixture and
then press the SET key. Use the left and right arrow keys to toggle between the values
Yes and No. Select the required value and then press the ENTER key.