Instruction manual

Quick Start Tutorial
Frog 2 Operating Manual – Issue 4.3 Page 23
Desk Setup
The Desk Setup function allows you to configure or customise the settings on the desk to
your own requirements.
Desk Setup is divided into a number of different sections which are accessed by pressing
the corresponding soft button on the touch screen:
A summary of the Desk Setup options is provided below. For details of the various options
refer to the Setup chapter in this manual.
• Displays - Indicate which monitors are connected; adjust the touch screen timeout,
brightness and contrast; re-calibrate the touch screen(s); adjust desk lamp brightness.
• Peripheral - Allow mouse or trackball to control pan and tilt parameters; display soft
keyboard on the touch screen, wheel sensitivity.
• Inputs – Set up SMPTE and MIDI Timecode; CAN; Set Time; Set Date. Assign
Remote Switches.
• Outputs – Configure DMX universe to DMX output sockets.
• Behaviour – Keep parameters separate options; Page Holdover if Active; Confirm
Overwrites; UDF and UDK actions; Tie UDF / Playback pages.
• Default Times – Set up the default delay and fade times for each attribute (Intensity,
Colour, Beamshape, Position) for all new recorded cues.
• Cue Stack Defaults – Set up the default options for all new cue stacks including
timecode and chase modifiers.
• Lock – Lock the desk; change the lock code (PIN).
• Event Monitor – Indicates each front panel action (slider movement, key press etc.)