Instruction manual

Introduction
Page 16 Frog 2 Operating Manual – Issue 4.3
Group, Attribute, Cursor Keys and Control Wheels
The GROUP key is used when selecting or recording groups. Pressing the GROUP key
brings up a tool bar on the touch screen containing the Master Groups.
The attribute keys (POSITION, COLOUR, BEAM and EFFECTS) are used when adjusting
fixture parameters and also when recording, referencing and outputting palettes and
effects. Each of these keys contains a red light, which is lit when the attribute is selected.
The cursor keys (up, down, left and right) are used to move around fields on the touch
screen or active monitor screen. These keys are equivalent to the four cursor keys on the
external keyboard.
The three control wheels are used for setting and adjusting fixture parameter and other
data levels. The parameters that are currently assigned to the control wheels are shown
on the bottom section of the touch screen.
The Frog 2 Development Team
Paul Ardron Electronic Design
Simon Aspland Software
Steve Chaplin Project Manager
Nigel Daft Manual, Testing, Documentation and Support Forum
Gareth Higginson PCB Design
Peter Kirkup Manual, Testing, Fixture Library
Nigel Upward Mechanical Design