Instruction manual

Macros
Frog 2 Operating Manual – Issue 4.3 Page 153
Macros
The Frog 2 desk provides a number of in-built macros and 200 user programmable
macros. The user interface provides mechanisms for recording, naming, running and
deleting user definable macros.
In-Built Macros
The desk provides a number of in-built macros as follows:
Playback Macros
These macros are used as commands in cue stacks to allow a cue to trigger an event
elsewhere on the console:
GX Go playback X on the current page.
GP/F Go playback F on Page P.
SX Pause playback X on the current page.
RX Release playback X on the current page.
PX Change the current page to X.
TS/C Trigger (Go) Stack S Cue C.
CX Choose playback X (turn the select LED on for playback X).
NC Go to Cue C in the same cue stack (does NOT trigger the cue).
NS/C Go to Cue C in cue stack S (does NOT trigger the cue).
Don’t Move on Dark Macros
These macros are used to prevent parameters moving on dark for a particular cue;
DM Don’t move on dark - All Parameters
DMB Don’t move on dark – Beamshape Parameters
DMC Don’t move on dark – Colour Parameters
DMP Don’t move on dark – Position Parameters
DMBC Don’t move on dark – Beamshape and Colour Parameters
DMBP Don’t move on dark – Beamshape and Position Parameters
DMCP Don’t move on dark – Colour and Position Parameters