Instruction manual

Effects
Frog 2 Operating Manual – Issue 4.3 Page 147
Effect Parameters
The following effect parameters are generated by the standard effects and may also be
applied to any fixture parameter as required via the Effects Window:
Parameter Range Default Notes
Function
None, Sine, Cosine,
etc.
None
The function that is applied to the individual
fixture parameter – see full list below.
Speed
- 100 to +100 0
The Speed parameter also determines the
direction of movement effects
Size
0 – 100 0
Offset
0 – 100 0
Sine Sine wave
Cosine Cosine Wave (Sine + 90deg)
Sine + 180 Sine Wave offset by 180deg
Sine + 270 Sine Wave offset by 270deg
Sine*2 Two sine waves in a single cycle
Step Snap On and Off (On for half cycle, off for other half)
Step + 90 Step offset by 90deg
Step + 180 Step offset by 180deg
Step + 270 Step offset by 270deg
Sawtooth 0% - 100% over first half of Cycle, 100% - 0% over second half
Sawtooth + 90 Sawtooth offset by 90deg
Sawtooth + 180 Sawtooth offset by 180deg
Sawtooth + 270 Sawtooth offset by 270deg
Ramp 0% - 100% over entire cycle (snaps back to 0%)
Ramp + 90 Ramp offset by 90deg
Ramp + 180 Ramp offset by 180deg
Ramp + 270 Ramp offset by 270deg
RampInv 100% - 0% over entire cycle (snaps back to 100%)
Mark On 0% for first and last 5% of cycle then snaps to 100% for rest of cycle
Mark Off 100% for first and last 5% of cycle then snaps to 0% for rest of cycle