Instruction manual

Introduction
Frog 2 Operating Manual – Issue 4.3 Page 13
Function and Numeric Keypads
Function Keypad
The Function Keypad contains 19 labelled function keys. For details of the functionality of
the different keys see the relevant sections of this manual. The TRY CUE, HIGHLIGHT,
BLIND and CLEAR keys contain a single red LED.
Numeric Keypad
The numeric keys (0 - 9) and the point key (.) are used for entering numeric data (eg group
no, palette no, cue no, channel levels, DMX addresses etc.)
The backspace key () removes the last instruction entered on the command line.
The slash key (/) is used for separating stack and cue numbers (eg 3/5 = stack 3 cue 5), or
fade up/down times (eg 2/5 = fade up 2 seconds, fade down 5 seconds).
The minus key (-) is used for removing items from a list (EXCEPT key).
The plus key (+) is used for adding items to a list (AND key).
The THRU key is used for selecting a range of items.
The FULL key is used to set the intensity of the selected fixture(s) to FULL (ie 100%).
The AT (@) key is used when setting intensity levels or DMX addresses.
The ENTER key is used for confirming or completing commands.