Instruction manual

Programming
Page 94 Leap Frog 48/96 Operating Manual – Issue 3
Fan Last Mode
The parameter value on each of the selected fixtures increases or decreases by a different
amount from their original values, depending on the fixture number. The value of the last
selected fixture will be locked. Example – Fan-Last Mode (Fixture 5 locked):
Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5
Original Value 50 50 50 50 50
New Value 30 35 40 45 50
Change in Value -20 -15 -10 -5 0
Fan V Mode
The parameter value on each of the selected fixtures increases or decreases by a different
amount from their original values, depending on the fixture number. The value of the
middle selected fixture will be locked. Example – Fan-V Mode (Fixture 3 locked):
Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5
Original Value 50 50 50 50 50
New Value 70 60 50 60 70
Change in Value +20 +10 0 +10 +20
Changing Wheel Editing Modes
To change the normal or shifted wheel editing mode – hold down the SETUP key and
press the required attribute key (eg COLOUR). The MFKs change to show the various
setup options for the selected attribute.
Select the [Normal Wheel Mode] or [Shifted Wheel Mode] key as required. The MFKs
change to show the wheel editing modes available.
Select the required wheel editing mode (eg Absolute). The MFKs return to the attribute
setup options. Select the [OK] key to complete the operation.