Instruction manual

Programming
Leap Frog 48/96 Operating Manual – Issue 3 Page 93
Relative Mode
The parameter value on each of the selected fixtures increases or decreases by the same
amount from its original value. This mode is most often used for adjusting position
parameters (pan and tilt). For example:
Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5
Original Value 10 20 30 40 50
New Value 15 25 35 45 55
Change in Value +5 +5 +5 +5 +5
Fan First Mode
The parameter value on each of the selected fixtures increases or decreases by a different
amount from their original values, depending on the fixture number. The value of the first
selected fixture will be locked. Example – Fan-First Mode (Fixture 1 locked):
Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5
Original Value 10 10 10 10 10
New Value 10 15 20 25 30
Change in Value 0 +5 +10 +15 +20
Fan Middle Mode
The parameter value on each of the selected fixtures increases or decreases by a different
amount from their original values, depending on the fixture number. The value of the
middle selected fixture will be locked. Example – Fan-Middle Mode (Fixture 3 locked):
Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5
Original Value 50 50 50 50 50
New Value 40 45 50 55 60
Change in Value -10 -5 0 +5 +10