Instruction manual

Programming
Page 92 Leap Frog 48/96 Operating Manual – Issue 3
Wheel Editing Modes
The desk provides a number of wheel editing modes which are user selectable and apply
when editing several fixtures at the same time.
For each attribute there is a normal and a shifted wheel mode.
The normal wheel mode is applied when the control wheel is moved. The shifted wheel
mode is applied when the SHIFT key is held down and the control wheel is moved.
The default wheel editing modes, a description of each mode and how to change the
wheel editing modes are described in the following sections.
Default Wheel Editing Modes
Each attribute has its own default wheel editing modes as defined in the table below:
Brightness Colour Beamshape Position Effects
Normal Mode
Absolute Absolute Absolute Relative Absolute
Shifted Mode
Fan First Fan First Fan First Fan First Fan First
Absolute Mode
The parameter value for all the selected fixtures goes to the same absolute value.
For example – Select fixtures 1 – 5 and adjust a parameter:
Fixture Parameter Fixture 1 Fixture 2 Fixture 3 Fixture 4 Fixture 5
Original Value 30 20 40 10 50
New Value 15 15 15 15 15
Change in Value -15 -5 -25 +5 -35