Instruction manual

Preset Operation
Leap Frog 48/96 Operating Manual – Issue 3 Page 81
Timed Fading Between Scenes
Set the Time to the required fade time, using Special Page 1 TIME button.
Set the A MASTER to full, and the B MASTER to zero. Set up a scene using the PRESET
A faders. Set up a different scene on the PRESET B faders. To initiate the timed
crossfade, quickly move the A MASTER to zero and the B MASTER to full.
The output will crossfade from Scene A to Scene B in the Crossfade Time (providing the
time taken to move the master faders was less than the indicated time).
To return to scene A, quickly move the A MASTER to full and the B MASTER to zero. The
output will crossfade from Scene B to Scene A in the Crossfade Time (providing the time
taken to move the master faders was less than the indicated time).
In each of the cases above the timed crossfades will be dipless. If the A or B MASTER
faders are only moved a proportion of their full travel, then the time taken to achieve the
final output state will be the same proportion of the internal Time.
Flashing Channels
The Flash Mode must be set to FLASH using the FLASH MODE key on Special Page 1.
The CHANNEL FLASH buttons below the PRESET A or PRESET B faders can then used
to flash individual channels to the level set on the GRAND MASTER fader. When a
channel is flashed, the LED will in the flash button will be lit to indicate the flash in
progress.
Soloing Channels
The Flash Mode must be set to SOLO using the FLASH MODE key on Special Page 1.
The CHANNEL FLASH buttons below the PRESET A or PRESET B faders are then used
to solo individual channels to the level set on the GRAND MASTER fader.
When a channel is soloed, all other dimmer channels and fixture brightness
channels are
reduced to zero, while the CHANNEL FLASH button is being held down. When a channel
is being soloed, the LED will be lit in the flash button to indicate the solo in progress.
Latching Channels
The Flash Mode must be set to LATCH using the FLASH MODE key on Special Page 1.
The CHANNEL FLASH buttons below the PRESET A or PRESET B faders are then used
to latch individual channels.
Successive presses of the CHANNEL FLASH buttons latch the channel on and off.
When a channel is latched on, the LED in the CHANNEL FLASH button is on.
When a channel is latched off, the LED in the CHANNEL FLASH button is off.