Instruction manual

Setup
Page 74 Leap Frog 48/96 Operating Manual – Issue 3
Zero Wire
Zero Wire DMX is a wireless DMX transmission system from Zero 88. The system can be
output directly from the console via the [Network] options in Setup, and can then be routed
via a Wireless Access Point to Zero Wire DMX boxes which decode the signal to DMX for
linking to fixtures and dimmers, etc.
In the Zero Wire setup page there are a host of options, which enable each DMX Universe
on the desk to be routed to an IP address with a unique Universe number (see below).
For more information, see the Zero wire DMX user manual, which can be found on the
Zero 88 website.
Select the required option eg [Transmit Zero Wire]. The MFKs change to display the
corresponding options or a numeric keypad. Use the MFKs to select the option or enter a
numeric value as appropriate. The following table summarises the Zero Wire options:
Option Range Default Notes
Transmit Zero Wire Yes or No No
Advanced options Yes or No No
IP Address 192.168.1.1
Subnet Mask 255.255.255.0 Advanced Option
Default Gateway 0.0.0.0 Advanced Option
Universe 1 Universe Disabled, 1 - 10 1
Universe 1 Target 192.168.1.255 Advanced Option
Universe 2 Universe Disabled, 1 - 10 2
Universe 2 Target 192.168.1.255 Advanced Option
Universe 3 Universe Disabled, 1 - 10 3
Universe 3 Target 192.168.1.255 Advanced Option
Universe 4 Universe Disabled, 1 - 10 4
Universe 4 Target 192.168.1.255 Advanced Option