Instruction manual

Setup
Page 70 Leap Frog 48/96 Operating Manual – Issue 3
Desk Information
Press the [Files] MFK or select the [Files] button on the Setup Window.
Press the [Desk Information] MFK or select the [Desk Information] button on the monitor.
The Desk Information screen is displayed on the monitor and contains information on the
various software, firmware and BIOS installed in the desk as follows:
Hardware Platform
Slave 1 Bootloader and Firmware
Slave 2 Bootloader and Firmware
Motherboard BIOS
NVR Location
Operating System Version
Software Version
Serial Number
Fixture Library Version
Current Show
Flash Size
Updating Software
This option allows you to update the operating software on the desk.
Copy the .upd file to a USB memory stick from your PC. Start the desk normally, and plug
the USB memory stick containing the update into one of the USB ports on the desk.
If you wish to save your show do so now as it will be cleared as part of the update process.
Press the [Files] MFK or select the [Files] button on the Setup Window.
Press the [Update Software] MFK or select the [Update Software] button on the monitor.
The desk will ask you to confirm the update, then the update will begin. Do not
disconnect
the power to the desk while this is occurring.
When the update is complete, the desk will prompt you to power-cycle the desk.
NOTE: It is important to check the release notes for each new version of software
as some may require alternative upgrade mechanisms.