Instruction manual

Setup
Leap Frog 48/96 Operating Manual – Issue 3 Page 67
Loading Shows
To load a show, connect the storage media to the USB port on the desk (any port). If
you’re using an external floppy drive, remember to insert the floppy disk into the drive.
Press the [Files] MFK or select the [Files] button on the Setup Window.
Press the [Load Show] MFK or select the [Load Show] button on the monitor. The Load
Show window is displayed on the monitor:
Select the required source device. A list of show files found on the selected device is
displayed in the window.
Select the required show file from the list (eg K-Nine Show 6).
Select the required Load Options. This defaults to Load Complete Show but you can just
load the Setup or Setup and Palettes if required.
Press the [OK] button to load the show.
Note – Loading Shows
Loading a show file will clear any existing show data from the desk so ensure that you
have backed up your previous show before you load another one onto the desk.
Show files from a Leap Frog 48 desk can be loaded into a Leap Frog 96 and vice versa.