Instruction manual

Setup
Page 50 Leap Frog 48/96 Operating Manual – Issue 3
The DMX-In Field
The DMX-In field in the Patch table shows the DMX In address assigned to the fixture (if
applicable). The DMX In channel is used to control the brightness
of the fixture.
This field may be blank (ie no DMX In control), or a value between 1 and 512. Clicking on
an entry in this column allows you to change the DMX In address assigned to the fixture.
Where a DMX-In Dimmer exists only on the DMX-In, the default fixture numbers start at
1001 onwards, relative to the DMX address of the fixture assigned, for example: