Instruction manual

Quick Start Guide
Leap Frog 48/96 Operating Manual – Issue 3 Page 33
Saving Shows
The Leap Frog 48/96 saves the show automatically to its internal memory at regular
intervals. External backups of the show data can be made to a USB Storage Device (eg
memory stick).
Connect your storage device to one of the USB ports on the desk. If using an external
floppy drive, remember to insert a floppy disk into the drive.
Press the [Files] MFK or select the [Files] button on the Setup Window.
Press the [Save Show ] MFK or select the [Save Show] button on the monitor. The Save
Show window is displayed on the monitor. Select the required Destination Device, by
pressing the relevant MFK. If you do not see your device immediately, press Refresh.
Now you can enter a name for the show file, using the MFKs like a mobile phone text
message. This name will be used as the file name on the destination device, so ensure it
is unique and easily identifiable. Once you have entered the name, press ENTER, then
press the [OK] MFK to save the show.
Loading Shows
Loading a show file will clear any existing show data from the desk so ensure that
you have backed up your previous show before
you load another one onto the desk.
To load a show, connect the storage media to a USB port on the desk. If you’re using an
external floppy drive, remember to insert the floppy disk into the drive.
Press the [Files] MFK, then press the [Load Show] MFK The Load Show window is
displayed on the monitor. Select the required source device, using the MFKs.
A list of show files found on the selected device is displayed in the window (this may
require you to use the Page Function to locate your show, if a lot of files are found on the
disk). Select the required show file from the list, then press the [OK] button to load the
show.
Clear Options
This section of Setup allows you to clear (delete) various components which make up the
show file (memories, submasters, groups, palettes etc.)
There is also a Reset Desk option which clears the show completely, resets the desk and
returns the setup parameters and DMX patch to the factory defaults.
Exiting Setup
Once you have finished making changes to the setup, press the SETUP key to exit setup.