Instruction manual

Introduction
Page 20 Leap Frog 48/96 Operating Manual – Issue 3
Wheel LCD and Control Wheels
Wheel LCD
The Wheel LCD is used to indicate which fixture parameters or other data are being
controlled by each of the three control wheels.
Example - When showing fixture parameter values - The Wheel LCD displays the
parameter name (eg Colour1) and the value in %, DMX or the parameter detail name.
Tag status is shown by inverse graphics – an inverted display shows a tagged parameter,
and a true colour display shows an untagged parameter.
Control Wheels
The three control wheels are used for setting fixture parameter levels and other data. The
names of the fixture parameters or other data currently assigned to each of the wheels and
their values is shown on the Wheel LCD.
Wheel Editing Modes
There are a number of wheel editing modes which apply when editing several fixtures at
the same time (Absolute, Relative, Fan First, Fan Middle, Fan Last, Fan V).
For each attribute there is a normal wheel mode which applies when the control wheel is
moved and a shifted wheel mode which applies when the SHIFT key is held down and the
control wheel is moved.
For further details on each of the wheel editing modes, and how to adjust the normal and
shifted mode for each attribute – see page 92 of the manual for full details.