Instruction manual

Introduction
Leap Frog 48/96 Operating Manual – Issue 3 Page 17
Playback X Controls
Playback X (Memory) Master Fader
The MASTER fader controls the maximum output level of the memory being output on the
Playback X. This fader only affects the dimmer and brightness fixture channels (if
applicable). The Colour, Beamshape and Position fixture channels are not affected by the
master fader.
Go Button
The GO button is used to initiate a crossfade between the memory currently being output
and the Next memory in the memory stack as indicated on the Memories screen.
Pause Button
The PAUSE button is used to pause a crossfade between the current and next memories.
When a crossfade has been paused, the red light in the button flashes. Pressing the GO
button releases the pause. Pressing Pause again will step backwards in the cue stack.
Override Control
The OVERRIDE control is used to slow down or speed up the crossfade between the
current and next memory. When the control is moved away from the central neutral
position, this is indicated on the monitor screen.
Step Button
The STEP button is used to manually step through any chase memory with manual drive
currently being output on the Playback X.