Instruction manual
Introduction
Page 16 Leap Frog 48/96 Operating Manual – Issue 3
Submaster Controls
Submaster Faders
The Submaster faders are used to output channel data (scenes) or chases. The fader
controls the output level of the intensity channels and triggers the LTP channels in the
programmed data.
Submaster Flash Buttons
The Submaster flash buttons, located below each of the submaster faders are used to
flash, solo or latch the data programmed on the submaster. The action of these buttons is
user definable via the Submaster Setup Window. These buttons are also used to select
submasters when in the Submaster Window.
Submaster Page Controls and Display
The current Submaster Page (1-20) is indicated on the dual seven segment display.
The PAGE UP and PAGE DOWN keys are used to select the required submaster page.
Pressing the PAGE UP and PAGE DOWN keys together selects submaster Page 1.
Submaster Step Button
The Submaster STEP button is used to manually step through any chases with manual
drive being output on the submasters, or to initiate Beat tempo matching.