Instruction manual

Macros
Leap Frog 48/96 Operating Manual – Issue 3 Page 153
Copying a Macro
Display the Macro window on the monitor. Select a programmed macro to be copied.
Press the COPY key. The Copy Window is displayed on the monitor:
Enter the destination (To) macro number and then select the [OK] button to confirm the
operation.
If the destination macro is unprogrammed – the source macro is copied to the destination
macro.
If the destination macro is programmed – a warning message is displayed. You then have
the option to overwrite the macro or cancel the copy operation.
Running a Macro
A macro can be run using any of the following methods:
• Click on the macro in the Macro Window on the monitor.
• Use the cursor keys to select the macro in the Macro Window and then press the
ENTER key.
• Press the MACRO key to make the MFKs macro selection keys. Use the PAGE UP or
PAGE DOWN keys to select the required page. Press the macro MFK.
• Triggering a memory with an associated macro.
• Raising a submaster with an associated macro.
Note – Running Fixture Macros
To run one of the automatic fixture macros (Reset, Lamp On or Lamp Off) select the
fixture(s) first before running the macro as described above.