Instruction manual

Effects
Leap Frog 48/96 Operating Manual – Issue 3 Page 149
Copying an Effect
Display the Effect Palette window on the monitor. Select a programmed effect to be
copied. Press the COPY key. The Copy Window is displayed on the monitor:
Enter the destination (To) effect number and then select the [OK] button to confirm the
operation.
If the destination effect is unprogrammed – the source effect is copied to the destination
effect.
If the destination effect is programmed – a warning message is displayed. You then have
the option to overwrite the effect or cancel the copy operation.
Outputting an Effect
Select the required fixture(s). Press the EFFECTS key to make the MFKs Effect Selection
Keys. Use the PAGE UP or PAGE DOWN key to select the required page.
Press the Effect MFK to output the data recorded in that effect for the selected fixture(s).
Note – Outputting Effects
When outputting an effect, if a selected fixture is not programmed in the effect, but there
are one or more fixtures of the same fixture type that are programmed in the effect, then
the fixture outputs the value that is programmed for the first fixture of that type.
Example – Fixture 1 (MAC 250) only is programmed in effect palette 5; no other fixtures
have programmed values in this palette. Fixture 7 (another MAC 250) references effect
palette 5. It sees that there is no value programmed for fixture 7 in this palette, but fixture 1
is the same fixture type and has a value, so it uses the value stored for fixture 1.