Instruction manual

Effects
Page 148 Leap Frog 48/96 Operating Manual – Issue 3
Editing an Effect
Editing an effect is carried out by first loading the effect into the Programmer, adjusting the
effect parameter values as required, and finally updating to save the edited effect back to
it’s original location.
Display the Effect palette window on the monitor. Select the effect to be edited, then press
the LOAD key. The Load Options Window is displayed on the monitor:
Select the [OK] button to load the effect into the Programmer.
Adjust the effect parameters as required using the control wheels.
Press the UPDATE key. The Update Options Window is displayed on the monitor.
Set the update options as required and then select the [OK] button to complete the edit.
Naming an Effect
Display the Effect palette window on the monitor. Select a programmed effect to be
named. Press the NAME key. The Name Window is displayed on the monitor:
Use the MFKs or external keyboard to enter the effect name as required, then select the
[OK] button to complete the operation.