Instruction manual

Submasters
Page 136 Leap Frog 48/96 Operating Manual – Issue 3
Latch
Press the required SUBMASTER FLASH button. The LED in the SUBMASTER FLASH
button comes on and the outputs are as follows:
The programmed dimmers in the scene, chase or transferred memory data on the
submaster snap to their programmed levels.
The fixture Brightness channels snap to their programmed levels.
The Colour, Beamshape and Position channels are triggered automatically and snap to
their programmed levels.
Press the required SUBMASTER FLASH button again. The LED in the SUBMASTER
FLASH button goes out and the outputs are as follows:
The dimmers and fixture brightness channels return to zero (or the level corresponding
to the submaster fader level if the fader is avove zero).
The Colour, Beamshape and Position channels are released.
Go
Press the required SUBMASTER FLASH button. The LED in the SUBMASTER FLASH
button comes on and the outputs are as follows:
The programmed dimmers and fixture brightness parameters in the scene, chase or
transferred memory data on the submaster fade up to their programmed values in the
submaster Fade Up time.
The Colour, Beamshape and Position channels are triggered automatically when the
internal submaster fader reaches the LTP trigger level and then fade to their
programmed levels in their respective fade times.
Press the required SUBMASTER FLASH button again. The LED in the SUBMASTER
FLASH button goes out and the outputs are as follows:
The dimmers and fixture brightness channels fade down to zero (or the level
corresponding to the submaster fader level if the fader is above zero).
The Colour, Beamshape and Position channels are released.
Off
Pressing the SUBMASTER FLASH button simply selects the submaster where applicable.
The outputs are not
affected.