Instruction manual

Submasters
Leap Frog 48/96 Operating Manual – Issue 3 Page 135
Submaster Flash Functions
The SUBMASTER FLASH buttons are used to flash or solo the programmed data on the
corresponding submasters. They can also be set to Latch or Go or may be switched off.
The default operation of the SUBMASTER FLASH buttons is defined in Desk Setup, but
you can set the function of individual flash buttons for programmed submasters via the
Submaster Setup Window.
Flash
Press and hold down the required SUBMASTER FLASH button:
• The programmed dimmers in the scene, chase or transferred memory data on the
submaster are flashed to their programmed level, and added into the current outputs.
• The programmed fixture Brightness channels are flashed to their programmed level.
• The programmed Colour, Beamshape and Position channels are triggered
automatically and snap to their programmed levels.
On release of the SUBMASTER FLASH button:
• The dimmers and fixture brightness channels return to zero (or the level corresponding
to the submaster fader level if the fader is avove zero).
• The Colour, Beamshape and Position channels are released
Solo
Press and hold down the required SUBMASTER FLASH button:
• The programmed dimmers in the scene, chase or transferred memory data on the
submaster are flashed to their programmed level. All other dimmers being output from
the presets, other submasters or Playback X are reduced to zero.
• The fixture Brightness channels are flashed to their programmed level. All other fixture
Brightness channel data being output from other submasters or Playback X is reduced
to zero.
• The fixture Colour, Beamshape and Position channels are automatically triggered and
snap to their programmed levels (providing the submaster fader is below the LTP
trigger level).
On release of the SUBMASTER FLASH button:
• The dimmers and fixture brightness channels programmed in the submaster return to
zero (or the level corresponding to the submaster fader level if the fader is avove zero).
All other dimmers and fixture brightness channels that were reduced to zero return to
their previous output values.
• The Colour, Beamshape and Position channels are released.