Instruction manual

Submasters
Leap Frog 48/96 Operating Manual – Issue 3 Page 121
Submaster Setup Window
The Submaster Setup Window allows you to do the following:
• Set the Flash button action.
• Set the LTP Trigger Level.
• Submaster Controls – Fade CBPE.
• Run a macro when the submaster fader is raised.
• Adjust the modifiers for a direct or transferred chase.
The data that is editable via the Submaster Setup Window is displayed in the Comments
field of the Submasters Window.
To display the Submaster Setup Window on the monitor and change the MFKs to display
the submaster setup options – hold down the SETUP key and press the corresponding
SUBMASTER FLASH key.
The actual options presented are dependent on the submaster selected. For example:
Use the MFKs or options in the popup window on the monitor to select the fields to edit
and adjust the options or values as required.
Flash Button Action
Select the [Flash Button Action] option, then select the required action (Flash, Solo, Latch,
Go or Off).
LTP Trigger Level
Select the [LTP Trigger Level] option, then enter the required level using the MFKs or
external keyboard. The LTP trigger level is the point at which the fade starts for LTP
parameters (moving light attributes).