Instruction manual

Introduction
Page 12 Leap Frog 48/96 Operating Manual – Issue 3
Preset Controls
Preset Faders
The Leap Frog 48 (96) desk has 48 (96) preset faders arranged as two rows of 24 (48)
faders and buttons. These control 24 (48) dimmer channels in two preset mode or 48 (96)
dimmer channels in Wide mode.
Channel Flash Buttons
The Leap Frog 48 (96) desk has 48 (96) flash buttons located below the PRESET faders.
The CHANNEL FLASH buttons are used to flash, solo or latch the dimmer channels or to
select the channels or fixtures assigned to the corresponding faders; their action being
determined by the setting of the FLASH MODE button in Special Page 1 of the MFKs.
A and B Master Faders
Two Preset Operation – The A MASTER fader controls the maximum output levels from
the PRESET A FADERS. The B MASTER fader controls the maximum output levels from
the PRESET B FADERS.
Wide Operation – The A MASTER and B MASTER faders control the maximum output
levels from all the PRESET faders or the stored scene according to the setting on the
PRESET CONTROL button.
Preset Control Button
The PRESET CONTROL button is only applicable in Wide Mode and is used to control
which of the A or B MASTER faders has control of the preset faders and which has control
over the stored scene. The red LEDs in the button indicate the current state. Pressing the
button swaps the function of the two faders.