Instruction manual

Memories
Leap Frog 48/96 Operating Manual – Issue 3 Page 117
Override Control
The OVERRIDE control slows down or speeds up time, allowing manual adjustment of a
crossfade as it happens.
Turn the OVERRIDE control anti-clockwise to slow down the crossfade between memories
or clockwise to speed up the crossfade.
Playback X Master Fader
The playback X MASTER fader controls the maximum output levels of the dimmers and
fixture brightness
channels only. The fixture colour, beamshape and position channels are
not affected by the Playback X MASTER fader.
Pause Key
Pressing the PAUSE key temporarily halts progression through the memory stack; the
LED in the PAUSE key flashes.
Pressing the PAUSE key again steps backwards through the memory stack (one memory
per key press). The fade times for the current memory are used. Any wait and delay times
defined for the memory are ignored.
Holding down the SHIFT key and pressing the PAUSE key snaps to the previous memory
(ie ignores all timing information).
Pressing the GO key releases the pause; the LED in the PAUSE key goes out.
Step Key
When the Current memory is a chase with a Manual drive modifier, the STEP key is used
to manually step through the chase.
When the Current memory is a chase with a Beat drive modifier, tapping the STEP key
twice is used to set the speed (beat) of the chase.