Instruction manual

Memories
Leap Frog 48/96 Operating Manual – Issue 3 Page 107
Setting Fade and Delay Times
Each memory has a set of fade and delay times which are applied to the dimmer and
fixture channel data programmed in the memory when the memory is played back.
The following fade and delay times are provided, which can be left at their default values
(as defined in Setup) or adjusted as required:
• Intensity Delay Up, Fade Up, Delay Down, Fade Down
• Colour Colour Delay, Colour Fade
• Beamshape Beamshape Delay, Beamshape Fade
• Position Position Delay, Position Fade.
The fade and delay times for each programmed memory are shown in the Memories
Window and may be adjusted using the front panel keys and control wheels or directly in
the Memories Window as described in the sections below.
Adjusting Fade and Delay Times using the Wheels
Select the memory to be edited.
Move the cursor to the Fade Up or Fade Down field.
The first finger control wheel adjusts the Intensity Fade times as follows:
• Moving the first finger wheel adjusts the intensity fade up and intensity fade down times
together giving them the same value.
• Holding down the SHIFT key and moving the first finger wheel adjusts the intensity
fade down time only.
• Once the times are split (ie different) the control wheel on its own adjusts the fade up
time. Holding down the SHIFT key and moving the wheel adjusts the fade down time.
• To re-join the two times – set the fade down time to the same value as the fade up
time, release the SHIFT key and then move the wheel.
The second finger control wheel controls the Intensity Delay times as follows:
• Moving the second finger wheel adjusts the intensity delay up and intensity delay down
times together giving them the same value.
• Holding down the SHIFT key and moving the second finger wheel adjusts the intensity
delay down time only.
• Once the times are split (ie different) the control wheel on its own adjusts the delay up
time. Holding down the SHIFT key and moving the wheel adjusts the delay down time.
• To re-join the two times – set the delay down time to the same value as the delay up
time, release the SHIFT key and then move the wheel.