Instruction manual

Memories
Leap Frog 48/96 Operating Manual – Issue 3 Page 103
Triggering Macros from a Memory
The Macro option in the Memory Setup Window allows you to specify a user defined
macro to be run when the associated memory is triggered on the memory stack. There are
also a number of don’t move macros which can be set for a particular memory as required.
Select the [Macros …] option in the Memory Setup Window. The Memory Macros popup
window is displayed on the monitor:
User Defined Macros
Select the [User Defined Macro] field or press the [User Defined Macro] MFK.
Enter the required macro number and then press ENTER to complete. Only valid
programmed macro numbers are allowed.
When a macro has been associated with a memory this is indicated in the Comments field
on the Memories Window, eg M:23.
Don’t Move Macros
The “don’t move” macros are used to prevent the desk updating the colour, beamshape or
position channel values where it would normally do so as part of the move on dark
operation. There is one MFK/button for each of the attributes. These macros can be
selected independently, as required.
Press the [Don’t Move Colour], [Don’t Move Beamshape] or [Don’t Move Position]
MFK/button as required to toggle between adding and removing the macro for the
memory. When the macro is added to the memory the LED in the MFK is lit, and the text
in the LCD above the MFK is displayed in inverse video.
When don’t move macro(s) have been associated with a memory this is indicated in the
Comments field on the Memories Window, eg DM:CBP.