Instruction manual

Memories
Page 102 Leap Frog 48/96 Operating Manual – Issue 3
Jumps in the Memory Stack
You can specify a memory number to jump to after the selected memory is run. This
allows you to jump forwards or backwards in the memory stack rather than playing the
memories back in numerical order.
Select the [Next] field in the Memory Setup Window. Enter the memory number to jump to
and then press the [OK] button. Only valid programmed memory numbers are allowed.
Notes – Jumps in the Memory Stack
In the Memory Setup Window the Next field defaults to blank indicating that the next
programmed memory in the stack will be triggered after the current one (ie no jump).
You can change the Next field as required to allow jumps in the memory stack and
therefore play back the memories in non-numerical order.
If a memory number is entered in the Next field, that memory number will be displayed in
the Comments column of the Memories Window, eg Next:123.
To remove a jump – press backspace to clear the Next field in the Memory Setup Window
and then press ENTER.
To remove ALL jumps from the memory stack – press the SETUP key, then select [Clear
Options], [Clear Jumps] and confirm.