Owner`s manual

General Maintenance
5.14
1. Remove the key from the key switch.
2. Press the Tension Tester steadily to the middle of the
upper side
of the belt. The “lip” will lead the tester on to
the belt.
3. Slowly increase the pressure on the tester, until you
hear a clicking
sound. Do not increase the pressure
after the tester has clicked.
4. Remove the tester carefully from the belt. Avoid rough
moveme
nts of the tester, as this would change the
results of the measurement. The measurement should
be in the range of 44-66 lbs (20-30 kg).
Drive Belt Adjustment Procedure
Note: Adjust both sides equally
.
1. Remove key from the key switch.
2. Loosen the rear axle nut (A).
3. Loosen the (left and right) 13 mm jam nuts (C).
4. Turn the (left and right) 13 mm ad
justment bolts (B) 1/4
turn at a time until the belt adjustment is within
specification.
Note: Belt tension will increase slightly when motor
mount bolts are fully torqued.
5. Tighten left and right jam nuts (C) to secure the belt.
6. Tighten the axle nut (A).
7. Test ride the motorcycle.
8. Recheck the belt for proper adjustment after the test
ride
and readjust, if necessary.